Price: $2,995.00 Fully programmable with an ordinary web browser, software provided onboard to change settings or update the firmware! Performance data is continuously streamed to the Ethernet port. It can work air cooled by programming lower power demands. For NEVDRA racers it can be programmed up to 1400Amps (EVnetics approval racing warranty must be agreed to in writing).

Soliton1 has heavy-duty industrial 600 Volt IGBT modules State of the art ultra low loss 600V film capacitor. No electrolytes to dry out and fail! ,weather-resistant terminals. Excellent cooling liquid or air heat dissipation. (1/2") high power terminals easy installation with separated battery and motor connections. Dithering is used for Smooth starts at low motor currents to maintain precise control and eliminate jerky starts without resorting to a huge drop in switching frequency. Motor protection voltage and current output in the forward and reverse directions can be independently limited. Adjustable switching frequency losses in any controller go up with switching frequency; the Soliton1 lets you choose between higher performance and efficiency (8kHz) or guaranteed silence at all current levels (14kHz programmable acceleration rate motor current traction control from a slow 100A per second to a tire-smoking 25,000Amps/sec. Built in Pre-charge Contactor, you don't need a separate contactor and resistor. Input terminals Protected against wiring errors reverse and over-voltage. All output terminals protected against short-circuit and inductive kickback. 3-wire throttle input: Throttle input accepts a 0-5V signal from a pot (1k to 5k ideal), Hall effect pedal, etc. Two dedicated inputs: Tachometer (1, 2, 4, 6 pulses per revolution) for protecting against motor over-speed and Brake, for inhibiting the motor output even if the throttle is "stuck on". Error lights report to the driver via the existing "Check Engine" light and other 12V indicators. Battery pack protection programming maximum current and minimum voltage getting the maximum performance and range from your pack without murdering them. New software program features can be added without removing your controller from the vehicle just upload the encrypted firmware through the web interface and reboot!

Soliton Jr. 8 to 340 Volts 600 Amps Peak: continuous current rating 500A with adequate liquid cooling. Price: $1,995.00 Same Programable capabilities The Soliton Junior is able of delivery up to 175kW (or 234HP!).

Features: * Idle: PID controlled. Makes converting vehicles with automatic transmissions, power steering, A/C, etc. much easier. * Battery pack protection: Both maximum current and minimum voltage on the battery side are programmable - protect your pack from abuse while extracting the maximum performance and range from your pack.

Kelly Controllers Kelly KDHB programmable high power series/PM for
brushed DC motor controllers provide efficient, smooth and quite controls for electrical vehicles.
some models come with regenerative braking.

Model Number	Motor Amps	Nominal Voltage	Input	Price	Shipping not included
Kelly Contollers
KDH14120D,series/PM	1200A	24-156V	0-5K	$1,899.00
KDH14100D, series/PM	1000A	24-156V	0-5K	$1,599.00
KDH14500B, series/PM	800A	24-156V	0-5K	$1,359.00
KDH14600D, series/PM	600A	24-156V	0-5K	$1,145.00
KDH14500B, series/PM	500A	24-156V	0-5K	$999.00
KDH12180D, series/PM	1800A	24-120V	0-5K	$2,399.00
KDH12150D, series/PM	1500A	24-120V	0-5K	$1,999.00
KDH12120D, series/PM	1200A	24-120V	0-5K	$1,699.00
KDH12100D, series/PM	1000A	24-120V	0-5K	$1,198.00
KDH12800B, series/PM	800A	24-120V	0-5K	$1,198.00
KDH12600B, series/PM	600A	24-120V	0-5K	$998.00
KDH12401A, PM with Regen	400A	24-120V	0-5K	$799.00
KDH09600B,series/PM	600A	24-96V	0-5K	$848.00
KDH12601A,PM with Regen	600A	24-96V	0-5K	$1,198.00
KDH09401A,PM with Regen	400A	24-96V	0-5K	$699.00

We provide Kelly controllers for a variety of different style electric motors brushed and brushless.
for more information call Jon at 702 2777544